Author: Site Editor Publish Time: 07-19-2024 Origin: Site
Professional Protocols for Optimal Results
Botulinum Toxin Type A delivers exceptional aesthetic and therapeutic outcomes – when prepared correctly. Improper handling can cause:
Reduced efficacy (up to 40% potency loss with vigorous shaking)
Inconsistent diffusion (leading to asymmetry or ptosis)
Patient safety risks (contamination or dosing errors)
Clinical Insight: A 2023 study showed proper reconstitution improves patient satisfaction by 58% (Aesthetic Surgery Journal).
Before you begin, gather the following materials:
Botulinum toxin type a vial (50, 100, or 200 units)
Sterile, preservative-free saline (0.9% sodium chloride)
Alcohol swabs
1mlSterile syringe (for 0.01mL precision)
30 gauge needle
Alcohol swabs & sterile gloves
1. Sanitization Protocol
Wipe vial stoppers with alcohol swabs
Critical: Allow 30 sec drying time (wet alcohol deactivates toxin)
2. Dilution Calculator
Treatment Area | Saline Volume per 100U | Concentration (U/0.1mL) |
Glabellar lines | 2.5mL | 4U |
Masseter reduction | 1.0mL | 10U |
Hyperhidrosis | 5.0mL | 2U |
Saline Injection Technique
Draw saline slowly to avoid bubbles
Inject along vial wall at 45° angle
Mixing Method
Rotate vial gently 10 times (→ never shake ←)
Quality Check: Solution must be crystal clear
Dilution: 2.5mL saline → 4U/0.1mL
Injection Plan:
3 injection points per side
0.05mL/site (2U) → Total 12U
Dilution: 1mL saline → 20U/0.1mL
Injection Plan:
Bilateral masseter, 0.15mL/side (30U)
Total 60U (remaining 140U for other areas)
❌ Mistake: Using refrigerated saline
→ Solution: Warm saline to room temp (cold increases pain)
❌ Mistake: Storing reconstituted toxin >24hrs
→ Evidence: Potency drops 15% after 12 hours (Plastic & Reconstructive Surgery, 2022)
❌ Mistake: Reusing needles between vials
→ Risk: Cross-contamination & protein denaturation
Diffusion Control:
High concentration (10U/0.1mL) → Localized effect
Low concentration (2U/0.1mL) → Wider spread
Pain Reduction:
Add 0.1mL lidocaine (1%) per 1mL saline (off-label)
Use 34G nano-needles for sensitive areas
Q: Can I use leftover toxin next day?
→ No. Discard after 24 hours (even if refrigerated)
Q: Why does my solution look cloudy?
→ Immediate discard required - indicates protein aggregation
Q: Best needle for precise dosing?
→ 1mL insulin syringe with 31G needle
Precision = Predictable Results
For authentic Botulinum toxin type a products and clinical support:
Contact Dermax Medical Team → CONTACT US!
Disclaimer: Protocols may vary by region. Always follow local regulations.
Dermax Products List
